Peavey IPS150

This forum is for talking about all kinds of Peavey power amplifiers.
Post Reply
artcarmo
New Member
Posts: 2
Joined: Thu Sep 24, 2009 1:51 am

Peavey IPS150

Post by artcarmo » Thu Apr 25, 2013 7:30 pm

Hi friends ,i got a peavey ips 150 from eBay,as is, of course ,when i received and check it i notice a burned +-15volt supply ,i replaced diodes caps clean the board and got all voltages in order,checked the outputs and fired up, it works great clean powerful sound in both channels ,but i notice the zener diodes very hot ,the +-15 volts are ok,no droops or variations, on the ic's the volts are ok ,and the amp works ,i want check it more deep ,so i'm looking for any advice or tip about other component that maybe drain more amps, but on the two 15v rails?...by the way i'm not sure if i'm in the right topic ,thanks in advance.
Attachments
The amp
The amp
250420134032.jpg (563.35 KiB) Viewed 1510 times
before
before
230420134025.jpg (446.53 KiB) Viewed 1510 times

Post Reply