want to turn1978 xr600 mixer/preamp section into a pedal
-
- New Member
- Posts: 1
- Joined: Thu May 23, 2013 3:15 am
want to turn1978 xr600 mixer/preamp section into a pedal
I have a xr600 from1978 thay doesnt work, but i would like to take the preamp and turn it into a pedal. Can someone help me in providing power to the board that holds the eq/ preamp dont need the amp to work i am just trying to power up the face. What kind of power should i use. Im somewhat novice, but can usually "mcgyver" things into other cool things. Any help would be greatly appreciated.
Re: want to turn1978 xr600 mixer/preamp section into a pedal
OK, so you have looked inside, and realize the mixer panel is really large, and would not fit into a common size pedal?
COntact customer service at peavey and ask for the schematic. I am assuming this s a real XR600, not an XR600B or later?
Look in your mixer. I think you will find a four wire cable connecting the mixer to the power amp. The four wires are:
+15v
-15v
ground
signal
That's it. YOu need a split supply providing 15vDC.
COntact customer service at peavey and ask for the schematic. I am assuming this s a real XR600, not an XR600B or later?
Look in your mixer. I think you will find a four wire cable connecting the mixer to the power amp. The four wires are:
+15v
-15v
ground
signal
That's it. YOu need a split supply providing 15vDC.