Help with dbx pa2 setup
Help with dbx pa2 setup
Hello I'm new to this product the Dbx pa2 drive rack. I feel like I'm not getting the full potential out if it. Currently I'm running 2 peavey pvx 15 with 1 qsc rmx 1450, for my subs I'm using 2 peavey sp218 with 2 qsc plx 3402 bridged. I tried to find the spec sheets for them to setup in the custom set in the dbx pa2 but can't find it any where so I have no idea how to set up the crossover on how many HZS for the high and the low. When I power them on it seems like my pvx over powers my subs which my subs are running at 3400 bridge per cab. If any can help me thx.
Re: Help with dbx pa2 setup
SP 218:
Minimum recommended active crossover frequency and slope for bi¬amping:
100 Hz at 24 dB/octave Linkwitz-Riley Low pass filter
Recommended Infra-sonic Filter:
36 Hz (-6 dB point) 24 dB/octave Linkwitz-Riley High-pass.
Minimum recommended active crossover frequency and slope for bi¬amping:
100 Hz at 24 dB/octave Linkwitz-Riley Low pass filter
Recommended Infra-sonic Filter:
36 Hz (-6 dB point) 24 dB/octave Linkwitz-Riley High-pass.
Peavey stuff:
2X- DJS sub's (USA)
2X- SP4 BX mains (USA
2X- QW 118's (USA)
IPR2 5000
IPR2 5000 DSP
IPR2 7500 DSP
PV 231 EQ
PV 215 EQ
Feedback Ferret D
XR 1220
2X- PV215's
PVI 4B
MS 212 cab (USA)
PV 14 AT
2X- SP15M (USA)
VIP 3
2X- DJS sub's (USA)
2X- SP4 BX mains (USA
2X- QW 118's (USA)
IPR2 5000
IPR2 5000 DSP
IPR2 7500 DSP
PV 231 EQ
PV 215 EQ
Feedback Ferret D
XR 1220
2X- PV215's
PVI 4B
MS 212 cab (USA)
PV 14 AT
2X- SP15M (USA)
VIP 3