Help with dbx pa2 setup

A general discussion forum to talk about all things Peavey and everything musical.
Post Reply
ChaChi
New Member
Posts: 1
Joined: Sat Mar 25, 2017 2:57 pm

Help with dbx pa2 setup

Post by ChaChi » Sat Mar 25, 2017 3:08 pm

Hello I'm new to this product the Dbx pa2 drive rack. I feel like I'm not getting the full potential out if it. Currently I'm running 2 peavey pvx 15 with 1 qsc rmx 1450, for my subs I'm using 2 peavey sp218 with 2 qsc plx 3402 bridged. I tried to find the spec sheets for them to setup in the custom set in the dbx pa2 but can't find it any where so I have no idea how to set up the crossover on how many HZS for the high and the low. When I power them on it seems like my pvx over powers my subs which my subs are running at 3400 bridge per cab. If any can help me thx.

0603Kenny
Member
Posts: 133
Joined: Fri Dec 27, 2013 10:40 am
Location: York, South Carolina

Re: Help with dbx pa2 setup

Post by 0603Kenny » Sun Mar 26, 2017 7:54 am

SP 218:
Minimum recommended active crossover frequency and slope for bi¬amping:
100 Hz at 24 dB/octave Linkwitz-Riley Low pass filter
Recommended Infra-sonic Filter:
36 Hz (-6 dB point) 24 dB/octave Linkwitz-Riley High-pass.
Peavey stuff:
2X- DJS sub's (USA)
2X- SP4 BX mains (USA
2X- QW 118's (USA)
IPR2 5000
IPR2 5000 DSP
IPR2 7500 DSP
PV 231 EQ
PV 215 EQ
Feedback Ferret D
XR 1220
2X- PV215's
PVI 4B
MS 212 cab (USA)
PV 14 AT
2X- SP15M (USA)
VIP 3

Post Reply