Hello Folks!
Can you please give me some info?
So I just bought a BUDDA super drive 80 II Head.
The manual is not clear (and doesn't give any example of connection). Just states the obvious: "use correct impedance"; "connect it properly to the speakers". Couldn't find any further info about it searching the web as well.
I have a HB 212 V30's cab (pics below).
- How should I properly connect the SD80 to my speakers?
- How many cables should I use?
- Should I use both outputs?
- Should I set my cab to Stereo or mono?
- Also, when turned ON, it has some kind of engine sound inside. Does it has a cooler running or something?
Thanks in advance.
OUTPUTS: https://drive.google.com/open?id=0BzPo8 ... ERvYXZlazg
Quick question - BUDDA Super Drive 80 II HEAD - How should I connect to my cab?
Re: Quick question - BUDDA Super Drive 80 II HEAD - How should I connect to my cab?
SImple.
In the speaker it says 8 ohm mono. Use the jack on that side, and switch set to mono/8 ohm
The two jacks in the amp are wired together. Pick one or the other. Set the impedance switch to match your cab - in this case 8 ohm.
Now plug a speaker cord from one of the amp jacks to the 8 ohm jack on the speaker. Use a real speaker cord, not just a guitar cord.
In the speaker it says 8 ohm mono. Use the jack on that side, and switch set to mono/8 ohm
The two jacks in the amp are wired together. Pick one or the other. Set the impedance switch to match your cab - in this case 8 ohm.
Now plug a speaker cord from one of the amp jacks to the 8 ohm jack on the speaker. Use a real speaker cord, not just a guitar cord.
Re: Quick question - BUDDA Super Drive 80 II HEAD - How should I connect to my cab?
Thank you!
I'll be using 1x 8ohm budda out - > 1x 8ohm in the cab (set to mono)
Cheers
I'll be using 1x 8ohm budda out - > 1x 8ohm in the cab (set to mono)
Cheers