Tube Layout in PV Ranger 212

This forum is for talking about all kinds of Peavey guitar amplifiers.
Post Reply
Telecastoff
Member
Posts: 37
Joined: Wed Mar 31, 2010 6:04 am

Tube Layout in PV Ranger 212

Post by Telecastoff » Thu Sep 14, 2017 10:23 pm

Does anyone here know the tube layout in a Ranger 212? Looking at the rear from right to left, and the specific function of each one of the 12AX7A's in there. Thanks.

User avatar
Enzo
Member
Posts: 9535
Joined: Fri Sep 12, 2008 10:24 pm
Location: Lansing, Michigan

Re: Tube Layout in PV Ranger 212

Post by Enzo » Fri Sep 15, 2017 7:24 pm

I don't know left from right, but the end nearest the input jacks is V1 end, and the four small tubes are V1-2-3-4 in that order.

V4 is the phase inverter, so it really part of the power amp.

V3 covers the preamp out (FX send) and the FX return.

V1a is the input stage for all channels, V1b is the clean channel.

V2 is only used for the drive channel. Both halves.

Telecastoff
Member
Posts: 37
Joined: Wed Mar 31, 2010 6:04 am

Re: Tube Layout in PV Ranger 212

Post by Telecastoff » Sat Oct 21, 2017 9:03 am

Thanks Enzo, much appreciated.

Post Reply