Peavey 1.3K amp

[edimusxero]

I have a general question about a Peavey 1.3k amp which I have recently acquired. My set up includes 2 1.3k amplifiers and a smaller 8.5C with 2 Peavey HDH 3's and 2 HDH 4's tri-amped.

I am trying to get a little more clarification to the set up as I recently blew out 1 pair of my subs and want to ensure that I do not do that again. I currently have the amps set to stereo mode and have them setup as the 2 channel mono mode as described in the manual. My speakers are connected using NL8's on the speaker end and then fanned out and connected via banana plugs on the amp end (will be re-wiring that to utilize the binding posts in the future). So my question is in 2 channel mono mode running 2 subs (left and right) how many watts / ohms are being pushed? I am not very good with all the technical jargon in the manual and want a little more clarification.

Also any suggestions on a better way to set this up would be appreciated as well.

Thanks

[Wooferhound]

Per Channel Stereo Mode
1000w into 2 ohms
650w into 4 ohms
400w into 8 ohms

Here is the info . . .
http://assets.peavey.com/literature/man ... 302085.pdf

[edimusxero]

oh perfect, so I'm running 400w into an 8ohm cab

Thanks

[colliedogboy1]

What subs are you using?

[edimusxero]

I'm running it into 2 Peavey HDH 3's which contains 2 BW 1801-8 each