Peavey 50/50 Mono Output

This forum is for talking about all kinds of Peavey power amplifiers.
Post Reply
bobbyz110
New Member
Posts: 1
Joined: Fri Jun 30, 2017 9:26 am

Peavey 50/50 Mono Output

Post by bobbyz110 » Fri Jun 30, 2017 9:49 am

I've searched the forum and read everything I could, but I haven't seen an explicit answer to my question. Looking for some help...

Why does the Peavey 50/50 have two jacks in parallel for each speaker output channel? and how do the speaker output channel jacks operate in mono mode?

For example, if I select mono mode, and I have a 2x12 cabinet in series with an 8ohm load... I would only need to use one output jack on the 50/50. Is that producing 100 watts?

On the other hand, if I select mono mode and I have two 2x12 cabinets (each 8ohms), for a 4ohm total load... and hook each cab up to one of the output jacks, are they getting 50 watts each?

Post Reply