How to set crossover frequencies on IPR2 3000 DSP

This forum is for talking about all kinds of Peavey power amplifiers.
Post Reply
HarleyD
New Member
Posts: 1
Joined: Fri May 24, 2019 9:07 pm

How to set crossover frequencies on IPR2 3000 DSP

Post by HarleyD » Fri May 24, 2019 9:14 pm

Hi,

How do you go about setting the low pass and high pass frequencies on the IPR2 3000 DSP? I see in the manual you can choose three type of crossover schemes, but setting the frequencies isn't explained, eg I want to set low pass on subs to 35Hz and high pass to 90 hz.

Thanks in anticipation.

Harley

colliedogboy1
Member
Posts: 768
Joined: Thu Sep 20, 2012 1:50 am

Re: How to set crossover frequencies on IPR2 3000 DSP

Post by colliedogboy1 » Wed May 29, 2019 12:50 am

It's one of those deals where you'll just have to mess with it in order to figure it out. Turn your amp's sensitivity (volume) controls full counterclockwise, get into the crossover mode and start pushing and twisting knobs.

Post Reply