FX32 Security Password removal/reset

This forum is for talking about all types of Peavey mixers.
Post Reply
Rogidyrog
New Member
Posts: 3
Joined: Mon Dec 19, 2016 7:27 pm

FX32 Security Password removal/reset

Post by Rogidyrog » Mon Dec 19, 2016 8:04 pm

Hi,

I've acquired a used FX32 just recently, and wanted to perform a factory reset. Apparently a security password had been set by someone previously, but I nor the previous owner has a clue what it was set to. In an attempt to resolve the issue, I did successfully flash the kernel to 133 (which already was the current kernel version), and updated the firmware to 1.31b3 as well. However this didn't resolve my issue and the password remained intact. Does anyone have any information or procedure to rectify my situation, please? Thanks :)

Roger

jim h
Member
Posts: 657
Joined: Fri Sep 12, 2008 11:20 pm

Re: FX32 Security Password removal/reset

Post by jim h » Tue Dec 20, 2016 5:02 pm

I sent you an email.

Molson
New Member
Posts: 2
Joined: Wed Jul 12, 2017 11:52 pm

Re: FX32 Security Password removal/reset

Post by Molson » Wed Jul 12, 2017 11:56 pm

I have the same issue. Could you please forward me the solution as well thanks!

scott.dickey
Member
Posts: 123
Joined: Thu Feb 07, 2013 8:40 am

Re: FX32 Security Password removal/reset

Post by scott.dickey » Thu Jul 13, 2017 8:23 am

Hi Molson,

I sent you an email.
Scott Dickey
Peavey Embedded Software Engineer

Molson
New Member
Posts: 2
Joined: Wed Jul 12, 2017 11:52 pm

Re: FX32 Security Password removal/reset

Post by Molson » Thu Jul 13, 2017 8:31 am

Thanks! I will give it a shot asap. Appreciate the help!

pr3lud3
New Member
Posts: 2
Joined: Fri Aug 18, 2023 6:15 pm

Re: FX32 Security Password removal/reset

Post by pr3lud3 » Fri Aug 18, 2023 6:17 pm

jim h wrote:
Tue Dec 20, 2016 5:02 pm
I sent you an email.
hey i just bought one of these from a local store and need help with this if you are still on the forum

jim h
Member
Posts: 657
Joined: Fri Sep 12, 2008 11:20 pm

Re: FX32 Security Password removal/reset

Post by jim h » Mon Aug 21, 2023 4:33 pm

Answered

Post Reply