Hello all,
I just started having a problem where my channel volume knobs are not effecting ANY of my channel volumes. I have a guitar, mic and a bluetooth signal all coming in yet I'm unable to raise or lower volume. The channels are simply not working. Any idea what's going on?
Main volume sliders works fine. I have a left & right monitor along with an external monitor being run thru the aux send out.
I'm completely unable to control each of these volumes as well as splitting these inputs between channels. I have signal and noise coming out of the speakers but it is doing this even when ALL channels volumes are turned down.
Any idea what the heck is up?
Roscoe
PV 10AT Volumes not working
Re: PV 10AT Volumes not working
I don't think the sliders will effect the volume using AUX SEND. There is a AUX volume knob for each channel. Tell us how you have your system connected.
Peavey stuff:
2X- DJS sub's (USA)
2X- SP4 BX mains (USA
2X- QW 118's (USA)
IPR2 5000
IPR2 5000 DSP
IPR2 7500 DSP
PV 231 EQ
PV 215 EQ
Feedback Ferret D
XR 1220
2X- PV215's
PVI 4B
MS 212 cab (USA)
PV 14 AT
2X- SP15M (USA)
VIP 3
2X- DJS sub's (USA)
2X- SP4 BX mains (USA
2X- QW 118's (USA)
IPR2 5000
IPR2 5000 DSP
IPR2 7500 DSP
PV 231 EQ
PV 215 EQ
Feedback Ferret D
XR 1220
2X- PV215's
PVI 4B
MS 212 cab (USA)
PV 14 AT
2X- SP15M (USA)
VIP 3