Page 1 of 1

Fx24 mixer hooking up a 2ch 31 band eq FOH

Posted: Thu Aug 03, 2017 6:56 pm
by drivond
I hooked up my eq from
1.left main output to ileft input to eq
Same for right side
Output from eq to amp both sides
Output from amp to speakers

The problem is if you mess with the main
sliders it affects the eq signal
_________________________________________
I bought 2 tip,ring and sleeve 1/4 on 1 end with a xlr male and female on the other end plugged into the eq one end is a return to mixer.
1/4 trs left side in the first output incert above the group incerts and the other 1/4 trs right next to the left side no signal to the eq no level.
I want to use the ext eq without affecting eq levels turning the master volume up or down. I want to eq the whole mix.
Thx
Dan

Re: Fx24 mixer hooking up a 2ch 31 band eq FOH

Posted: Fri Aug 04, 2017 11:07 pm
by colliedogboy1
Sounds like you had it hooked right in the first instance. What happens to the EQ signal when you raise or lower the main sliders on your mixer?

Re: Fx24 mixer hooking up a 2ch 31 band eq FOH

Posted: Wed Aug 09, 2017 8:26 am
by drivond
When raising or lowering the main sliders the EQ signal goes up or down I would prefer that it not change.

Re: Fx24 mixer hooking up a 2ch 31 band eq FOH

Posted: Thu Aug 10, 2017 6:21 pm
by Stryker57
not sure what your meaning... if you side the main left and right sliders up the signal to the eq increases?

if thats what you are saying, i belive thats how the mixer is designed to operate,

however the greatest thing about the fx series is it has many different options for it to be run so we'll need a few more details on what is going on and what your desired result is ,before we can offer suggestions to solve your problem

in short though ..
however you hooked it up without the eq ....
it should run identical as long as you simply inserted the eq into the chain between the mixer and amp.

but if this is your 1st time setting it up we''ll need more info .

Re: Fx24 mixer hooking up a 2ch 31 band eq FOH

Posted: Sat Aug 12, 2017 9:13 am
by drivond
Hello
When the master level faders on the mixer increase in volume the external eq signal level on the eq increases, just the opposite when you lower the master level faders on the mixer. I want the eq level to be adj on the limiter knob on the eq only my understanding is that it is possible to run a tip,ring,sleeve from the main output incerts 1/4" TRS on the mixer than plug the male and female xlr into the input and output on ea channel on the eq the output from the eq is a return to the mixer. The main outputs are run directly to the amp I cannot get a signal from the mixer to the eq. Do the incert output channels need to be turned on?

Re: Fx24 mixer hooking up a 2ch 31 band eq FOH

Posted: Sat Aug 12, 2017 3:35 pm
by colliedogboy1
If you want to EQ the whole mix, you need only connect the mixer's Main Output into the EQ's input, then connect the EQ's output to your amp's Main Input. It's like water flowing down a creek--there is no return to the mixer involved.
If you wanted to EQ a single channel, then you would use an Insert Cable on the "Insert" jack on that channel to send signal to the EQ (input) and return it (EQ output) back to that single channel.