Unity Series 2000 mixing board, fader knobs broken off
Unity Series 2000 mixing board, fader knobs broken off
On several channels, the knob and the metal stem that hold the knob on are snapped off. It seems impossible to make the metal stem snap back on. Do I replace the whole slider pot mechanism, or do I replace the piece that slides on the inside? I need to find a replacement part. It says "T015c 10K 9021". Can anyone give me a link to the exact part I need? If not, can anyone tell me if I am looking for a linear taper or log taper potentiometer? Also, if I find one with the same dimensions, can I simply pull the sliding piece out of the inside and use it on the existing fader? Do I pry it right off the board, or is there some gentler way? Thanks for any advice.
-
- Member
- Posts: 768
- Joined: Thu Sep 20, 2012 1:50 am
Re: Unity Series 2000 mixing board, fader knobs broken off
When you are on Peavey's "Support" page, click on "Contact Information" and you will find telephone numbers to call for help.