How do you setup gain between the board/crossover/power amp????

This forum is for discussions on the various types of Peavey processors and effects.
Post Reply
edrdrums
New Member
Posts: 1
Joined: Wed Aug 02, 2017 1:51 pm

How do you setup gain between the board/crossover/power amp????

Post by edrdrums » Wed Aug 02, 2017 1:59 pm

I just bought a PV23XO crossover.

There's not a clip light for the Input level on this crossover.

What is the best methodology to setup a good signal gain from the board output to the crossover..... then the low output to subwoofer amplifier?

I'd love to avoid overdriving or clipping units in this chain.

Thanks!

Post Reply