Peavey

IPR2™ 7500 Lightweight Power Amp

The Peavey IPR2™ 7500 delivers high-output, two-channel amplification in a lightweight design. Its high-speed Class D topology and resonant switch-mode power supply combine efficient power delivery with reduced weight and heat, making it easier to bring serious power to your setup.

Built for demanding use, the IPR2 7500 supports speaker loads as low as 2 ohms. Peavey’s DDT™ (Distortion Detection Technique) circuitry helps protect drivers and preserve sonic integrity during overload conditions, while additional protection circuitry guards against thermal, DC, subsonic, load and voltage issues.

Each channel offers selectable 100Hz high-pass, full-range or low-pass operation, with front-panel level controls and LED status indicators. Three temperature-controlled, variable-speed fans manage cooling.

SKU: 03004250
  • High-speed Class D amplification with a resonant switch-mode power supply for efficient, lightweight performance.
  • 3,750 watts per channel at 2 ohms, with both channels driven at 1kHz and 1% THD.
  • Supports speaker loads as low as 2 ohms.
  • DDT™ distortion detection helps protect drivers and maintain sonic integrity during overload conditions.
  • Selectable 100Hz high-pass, full-range and low-pass operation on each channel.
  • Independent front-panel level controls and Active, Signal, DDT, Temperature and DC indicators for each channel.
  • Three temperature-controlled, variable-speed cooling fans.
  • Protection against thermal, DC, subsonic, incorrect-load, undervoltage and overvoltage conditions.
IPR2™ 7500 Lightweight Power Amp image 0

IPR2™ 7500 Lightweight Power Amp

$1,449.99 $1,099.99
$1,449.99 $1,099.99

FAQ

Rated Watts 2ch x 2 ohms 4750 watts 20ms repetitive burst / 3750 watts 1% THD both channels driven @ 1kHz.

Rated Watts 2ch x 4 ohms 2800 watts 20ms repetitive burst / 2450 watts 1% THD / 2020 watts 0.15% THD, both channels driven @ 1kHz.

Rated Watts 2ch x 8 ohms 1550 watts 20ms repetitive burst / 1425 watts 1% THD / 1200 watts 0.15% THD, both channels driven @ 1kHz.

Minimum Impedance 2 ohms

Maximum RMS Voltage Swing 124 volts

Frequency Response 20Hz - 25kHz; +0dB, -3dB

20Hz - 20kHz 2ch x 2 ohms <0.5% @ 3280 watts 20Hz to 4kHz, decreasing to 3000 watts @ 20kHz, both channels driven.

20Hz - 20kHz 2ch x 4 ohms <0.15% @ 2000 watts 20Hz to 20kHz, both channels driven.

20Hz - 20kHz 2ch x 8 ohms <0.15% @ 1200 watts 20Hz to 20kHz, both channels driven.

Input CMRR > - 75dB @ 1 kHz.

Voltage Gain x 40 (+32dB)

Crossover 100Hz switchable 2nd order high pass and 3rd low pass per channel.

Crosstalk > -85dB @ 1kHz @ 1000 watts power @ 8 ohms.

Hum and Noise > -106dB, “A” weighted referenced to rated power @ 4 ohms.

Slew Rate > 12V/μs

Damping Factor (8 ohms) > 200:1 @ 20Hz - 1kHz @ 8 ohms

Input Sensitivity 2.25 volts +/- 3% for 1kHz 4 ohm rated power, 2.195 volts +/- 3% for 1kHz 2 ohm rated power

Input Impedance 20 kilohms, balanced and 10 kilohms unbalanced.

Current Draw @ 1/8 in VA (watts) 2210 (1440) @ 2 ohms, 1550 (950) @ 4 ohms, 982 (560) @ 8 ohms

Current Draw @ 1/3 in VA (watts) 4260 (3150) @ 2 ohm, 3120 (2160) @ 4 ohms, 1890 (1200) @ 8 ohms

Idle Consumption 250VA, 120 watts.

Cooling 3 temperature dependent variable speed fans.

Controls 2 front panel attenuators, crossover select switch for HPF, Normal and LPF

Indicator LEDs Five LED indicators per channel: Active, Signal, DDT, Temperature and DC

Protection Thermal, DC, subsonic, incorrect loads, under and over voltage

Connectors Inputs: Dual combination 1/4” XLR, Outputs: Dual 1/4” thru, one 2-pin & one 4 pin twist-lock connector

Construction 0.062” thick aluminum

Dimensions 3.5”x19”x 17” behind front panel + 0.6” for handle

Net Weight 6.61kg (14.6lbs.*)

Gross Weight 8.34kg (18.4lbs.)

Rated power readings made with BW: 20 Hz to 22 kHz. All power measurements made @ 120 VAC or 240VAC.
2 ohm steady state sine wave power is time limited by circuit breaker.
Bridge operation is not possible.
*Net Weight does not include power cord.

IPR2 7500 Specsheet

IPR2 translations

IPR2 5000/7500 Manual

If you have questions concerning product operation, support or warranty, please Contact Us!

We can also be reached by phone at 877-732-8391 (toll free in the US).

WARNING: This product can expose you to chemicals, including DEHP, which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Find Your Perfect Match

Artists